Gavin is selling:

  • As new (1700km)  LS1 clutch kit, including flywheel and slave cylinder - $400.00,
  • 4 Sets of steering stops - $10.00 per pair,
  • 1 x Diff cover stiffener rings, ready to fit, powder coated black. - $60.00 each
  • Tremec T56 Gearstick Mod.   This mod places the gearstick between the two OEM stick locations putting the gearstick in a better, more natural location for the Cobra, not too far back and not too close to the dashboard.

Price on application and requires your gear-stick unit on an exchange basis.

Contact Gavin

1973 Cobra:

Mark Singleton is selling his crown based 1973 Cobra for $35,000, details are as follows: Standard 351 Windsor, T56 trans, bit of a whine in 5th and 6th, 9 inch rear end with 4.11 gears, new 600cfm quick fuel carbie, new brake master cylinder, new rear brake shoes, a couple of oil leaks that need to be fixed, owned since 2003 but not driven much anymore.   Contact our club secretary, Andrew for further details.

Contact Andrew

OMP 4 Point Race Belts:

Miles Wood is selling a set of OMP Four Point Race Belts, 3" shoulder, 2" lap.   FIA approved, only worn on a few Sunday's going to church (Targa West).   The bee's knees of safety belts and approved for ALL motor sports events.   Cost new $270, will sell for only $150.00. (update Nov 17) Will sell for "first reasonable offer".

Contact Miles

Number Plates 

Aaron is selling set of acrylic personal number plates.   Front plate is 372 mm x 100 mm and rear plate is 372mm x 134 mm.

These plates are currently not in use and going for the bargain price of $655.00


Contact Aaron 

The items shown below are listed on behalf of Warren from the Cobra Car Club of Queensland.   All goods are in stock in Australia and available for shipment within a few days of confirmation of payment.   Warren can be contacted on 0427 892 745 or by clicking the link   Contact Warren

Side Pipes   

Click here for detailed info.


Jack Pads (Quick Jacks)

$360.00 for a set of four ( 2 x left & 2 x right) Fully polished stainless steel not chrome plated and no untidy welds.


$440.00 for a set of four ( 2 x front & 2 x rear).   Fully polished stainless steel fitted with mounting brackets and predrilled mounting holes on the innerside of the front overriders for fitment of the front bumper or nudgebar.   ALSO, not found in most overriders, an additional closed section at the top of the back of each overrider of polished stainless steel which is much more attractive than the standard open style.

Front Nudge / Bumper Bar

$385.00.   Fully polished stainless steel (not chrome plated steel) with side mounting plate for attachment for fitting to overriders.

Rear Nudge / Bumper Bar 

$385.00.   Fully polished stainless steel (not chrome plated steel) complete with mounting brackets already fitted.

Wind Wings (pair)

$110.00.   Acrylic not Lexan or Plexiglass which scratches, crack and discolours much easier.   Made with 4.5mm Adrylic with all edges polished to look like glass. 

Wind Wings Mounting Kit

$75.00.   To fit both sides.

Cobra Floor Mats

Price on Application


Powered by Wild Apricot Membership Software